sabine fbx 2400 rukovodstvo na russkom yazike

The FBX is designed to replace the graphic equalizer’s function for eliminating feedback. This can occur if either side of the balanced output is grounded at any point (or when mixing balanced and unbalanced inputs and outputs). If you don’t, you may experience a loss of gain (up to 6 dB) when using the FBX. Similarly, if your mixer is wired for balanced 1/4' Tip-Ring-Sleeve (TRS) outputs, you must use that type of connector. Note: If you’re using a mixer with unbalanced 1/4' outputs, you must use standard unbalanced cables and connectors when connecting it to the FBX. This targets the feedback control to the mics that need it. An even better solution is on a mixer insert point for a single channel, or a subgroup (see application diagrams in Section Two - Applications). In this position, the FBX can sense and eliminate feedback occurring in any channel of the mixer. The most common patch point is between the output of the mixer and the input of a power amp. The instructions presume that you are familiar with the fundamentals of sound reinforcement.Ĥ.1.1. Your FBX Feedback Exterminator will improve any sound reinforcement system. The 2400 is a dualmono version of the 1200. These instructions apply to both the FBX1200 and the FBX2400. It is possible to have both 1/5 and 1/10 octave constant 'Q' filters active in one channel simultaneously. Press the button at any time to select wider filters for any new filters to be set. When the LED corresponding to the desired number of fixed filters lights, press the Number Fixed button to register your selection. The LEDs ( 8) will begin to light in sequence. Set the number of available fixed filters by pressing the NUMBER FIXED button ( 6) until the LEDs stop flashing, then release it. for enabling and setting the Dynamic Filter Timer. Press and hold this button until the Dynamic filter flash and LEDs go off to reset all Dynamic filters. The LED ladder indicates the signal strength relative to the FBX's input clip level. The red BYPASS LED lights when the unit is in bypass mode. In active mode, the unit controls feedback automatically. Press READY again to lock the Fixed filters.īypass mode takes the unit out of the signal path so that it will have no effect on the program. Alternatively, you may enter READY status with fewer Fixed FBX filters in place, simply by pressing the READY button at any time. The total number of filters available for feedback filtering is 12 in the factory default setting, your unit will automatically enter READY mode when the tenth filter is set. This indicates your unit is ready for operation. The READY LED lights when the automatic FBX setup process has completed, or the READY button has been pressed. Filter LEDs (light emitting diodes) will flash 5 times and the SETUP LED will begin to flash. Press and hold this button to begin the FBX setup mode.

Sabine fbx 2400 rukovodstvo na russkom yazike